Humidity Control Setpoint Submenu - Trane IntelliPak I Programming, Troubleshooting Manual

Derived Zone stp Dead:
1. Pressing the NEXT key will scroll forward through the screens.
Humidity Control
Press ENTER to Review or Adjust
1. Pressing the NEXT key will bypass this section.
Dehumidify if Space Humidity Above
Occ Dehumidification Setpoint:
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed (if
applicable)
Stop Dehumid if Space RH Below STP Minus
Occ Dehumid Hysteresis Offset:
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed (if
applicable)
Dehumidify if Space Humidity Above
Unocc Dehumidification Setpoint:
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed (if
applicable)
Stop Dehumid if Space RH Below STP Minus
Unocc Dehumid Hysteresis Offset:
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed (if
applicable)
RT-SVP04F-EN
xx.xF
SETPOINT Submenu
60%
5%
60%
5%
System Programming SETPOINTS
Used With: CV units w/ one stp
only 2.0 -10F DEFAULT 4.0
USED WHEN ONE SETPOINT IS
AVAIL.
Used With: All units with
Dehumidification or Humidification
option installed.
Used With: All IntelliPak units with
Dehumidification option installed
Factory Preset: 60%
Possible Values: 40-65%
Used With: All IntelliPak units with
Dehumidification option installed
Factory Preset: 5%
Possible Values: 3-10%
Used With: All IntelliPak units with
Dehumidification option installed
Factory Preset: 60%
Possible Values: 40-65%
Used With: All IntelliPak units with
Dehumidification option installed
Factory Preset: 5%
Possible Values: 3-10%
91