Trane IntelliPak I Programming, Troubleshooting Manual page 26

System Operating Status
RTM Supply Fan Relay:
RTM Supply Airflow Proving:
1. Pressing the NEXT key will scroll forward through the screens.
2. Pressing the PREVIOUS key will scroll backwards to view the previously displayed screen.
3. Press the + (Plus) key while viewing any screen to add that screen to the custom menu. Refer to the custom
menu for the creation and maintenance of customized menus.
4. Press the NEXT key until the following screen is displayed. (if applicable)
Supply Fan IGV/VFD Cmd
Active Supply Air Pressure
1. Press the NEXT key until the following screen is displayed.
Active Supply Air Pressure
1. Press the NEXT key until the following screen is displayed.
Exhaust Fan OFF
1. Press the NEXT key until the following screen is displayed.
Exhaust Fan ON
Exhaust Damper/VFD
1. Press the NEXT key until the following screen is displayed. (if
applicable)
Note: "Exhaust Fan" and "Exhaust Damper/VFD" is shown only if
"Power Exhaust Config" is not = NONE
"Exhaust Fan" is not shown if Return Fan is installed
"Space Pressure" is shown only if Power Exhaust or Return
Fan with Statitrac is installed
26
OFF
FLOW
Opening To
OR
2.0 IWC
OR
Space Pressure 0.00 IWC
Opening to 32 %
Used With: All Units
Possible Values: Fan = ON, OFF
Airflow = FLOW, NO FLOW
30% Used With: All units with IGV/VFD.
Active SAP only shown if SAP is
2.0 IWC
present.
Possible Values: Opening to/
Closing to: 0-100%; Active Supply
Air Pressure= 0.0 -7.9 IWC
Used With: Rooftop units and Air
Handlers when IGV/VFD is not
installed and valid SAP sensor is
present.
Possible Values:
IWC
Used With: All units when Power
Exhaust without Statitrac is installed
without Return Fan
Possible Values: Fan= ON/OFF,
Used With: All units when Power
Exhaust with Statitrac is installed
without Return Fan
Possible Values: Fan= ON, OFF,
Damper/VFD = 0 to 100%
0.0 IWC - 7.9
RT-SVP04F-EN