Trane IntelliPak I Programming, Troubleshooting Manual page 115

GBAS 0-10 VDC Module Analog Outputs
#1 0 v #2 0 v
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
4. Repeat steps 1 and 2 for the next value.
5. Press the NEXT key until the following screen is displayed (if
applicable)
Status/Annunc Test
Heat: OFF Cool: OFF
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
4. Repeat steps 1 and 2 for the next value.
5. Press the NEXT key until the following screen is displayed (if
applicable)
Start Test In
Press TEST START To Begin, STOP To Halt
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
4. Repeat steps 1 and 2 for the next value.
5. Press the NEXT key until the following screen is displayed (if
applicable)
RT-SVP04F-EN
#3 0v #4 0v
Sys On (Blinking)
Service: OFF
System Testing & Troubleshooting
Used With: All Units when GBAS 0-
10 VDC is installed
Possible Values: 0-10.0 v
Used With: All Units
Factory Presets: OFF
Possible Values: HEAT = ON, OFF
COOL = ON, OFF
SERVICE = ON, OFF
Used With: All Units
Factory Presets: 5 Seconds
Possible Values: 0 to 120 Seconds
115