System Programming Setup; Setup Menu - Trane IntelliPak I Programming, Troubleshooting Manual

After the unit is installed, the control module must be programmed with certain SETUP
information in order to operate and function properly. The data necessary for unit
operation will vary depending on certain factors such as unit size, type, and installed
options.
This section of the manual provides step by step instructions for programming this
information. Also provided are instructions for checking unit operating status, accessing
and clearing diagnostics, and performing service tests.
Some of the displays shown in this manual may not appear on the Human Interface (HI)
LCD screen during programming. Only the applicable screens for the specific unit
options and operating parameters will be displayed.
Start with the first SETUP screen in the SETUP menu and program the necessary
information by completing the steps located below each illustrated window.
Information that pertains to when the screens are applicable, the factory preset values,
and the possible values that may be designated is located to the right of each
programmable screen.
Ignore the steps that do not apply to your unit and application, and move on to the next
applicable set of instructions in the manual. Continue this process until all applicable
screens are programmed with the required information.

SETUP Menu

The SETUP menu is used to input initial operating information such as control
parameters, SETPOINT source selection, sensor source selections, ventilation override
definitions, functions enable/disable, status, text display (language), temperature
display (C or F), and system tuning parameters. When a SETUP screen is displayed for
30 minutes without a key being pressed, the LCD screen will revert to the appropriate
power-up display. If this happens, press the SETUP key again to return to the SETUP
menu.
Note: Many of the screens displayed in this section are applicable only for the options
Press the SETUP key to begin viewing or modifying the SETUP screens.
If a screen is not visible on the Unit Human Interface Module, refer to the "Used With"
information listed to the right of each screen in this book.
Press the SETUP key to display the following screen.
RT-SVP04F-EN

System Programming SETUP

that are installed in the unit and may not be visible on your unit.
53