Stop Key; Test Start Key (Service); Custom Key - Trane IntelliPak I Programming, Troubleshooting Manual

General Information

STOP Key

Pressing the STOP key will cause the unit to transition to the stop state. If the current
display is editable, pressing the STOP key will cancel the desired edit.

TEST START Key (SERVICE)

Pressing this key while viewing any screen in the SERVICE Mode menu will start the
service test. When viewing status, SETUP , SETPOINT, and diagnostics screens, it has no
function.

CUSTOM Key

The Custom menu is simply a status menu that contains screens that the user monitors
most frequently. The Custom menu can only contain five status screens. To create the
Custom menu, press the STATUS key, followed by the NEXT key (this brings up the
initial status screen). If you want to add this screen to the Custom menu, press the +
(Plus) key, if not, press the Next key again until a status screen appears that you would
like to add to the Custom menu. Pressing the + (Plus) key while viewing any of the
various status screens will add that screen to the Custom menu. Once the Custom
menu is programed it can be accessed by pressing the CUSTOM key. To remove a
status screen from the Custom menu, press the CUSTOM key, then press the NEXT key
until the status screen that you want to remove appears, then press the - (Minus) key.
14 RT-SVP04F-EN