Outside Air Ventilation Setup Submenu - Trane IntelliPak I Programming, Troubleshooting Manual

For Dehumid OVRD Zone Temp, Use Sensor
Connected To: RTM ZONE TEMP INPUT
For Zone Reset Function, Use Sensor
Connected To: RTM ZONE TEMP INPUT
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
Monitor Specific Temp Input, Use Sensor
Connected To: RTM ZONE TEMP INPUT
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
End of Submenu (NEXT) to Enter SETUP
1. Press the NEXT key to leave the submenu and show following
screen.
2. Press PREVIOUS to page back through the submenu.

Outside Air Ventilation Setup Submenu

Press ENTER to Review or Adjust
1. Pressing the NEXT key will bypass this section.
Demand Controlled Ventilation:
_________________________
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key to advance the cursor.
4. Repeat steps 1 and 2 for the next value.
5. Press the NEXT key until the following screen is displayed
(if applicable).
RT-SVP04F-EN
DISABLED
System Programming SETUP
Used With: All units with
Dehumidification installed.
Factory Preset: RTM Zone Temp
input
Possible Values: RTM Zone Temp
input, NSB Panel Temp Sensor input,
RTM Aux Temp input, Heat Module
Aux Temp input, ECEM Return Air
Temp input (See below for detail)
Used With: All Units
Factory Preset: RTM Space
Humidity Input
Possible Values: RTM Zone Temp,
NSB Panel Temp Sensor Input, RTM
Aux Temp Input, Heat Module Aux
Temp Input, ECEM Return Air Temp
Input
Used With: All Units
Factory Preset: RTM ZONE TEMP
INPUT
Possible Values: RTM ZONE TEMP
INPUT, NSB PANEL TEMP SENSOR
INPUT, RTM AUX TEMP INPUT, HEAT
MODULE AUX TEMP INPUT, ECEM
RETURN AIR TEMP INPUT, NO
SENSOR SELECTED
Used with: All Units when Fresh Air
is configured other than NONE
Used With: All units with Fresh Air
Measurement w/DCV (VCM) or OA
Damper Min Position w/DCV
installed.
Factory Preset: Disabled
Possible Values: DCV SETPOINT
Modified By Space CO
2
Enabled), BLANK (If Disabled)
Level (If
63