Set Mode - Icom IC-7410 Instruction Manual

10

SET MODE

The Set mode is used for programming infrequently
changed values or functions.
D
q Hold down [MENU] for 1 second to enter the Set
mode.
w Push [Y](F-1) or [Z](F-2) to select the desired
item.
e Rotate [DIAL] to select the desired option.
ting, if desired.
r Push [MENU] to save, and exit the Set mode.
1.
2.
Regardless of this setting, the LCD backlight
sign. (It is not an equipment malfunction.) Then, the
brightness level automatically returns to the ad-
justed value.
3.
Adjust the confirmation and band edge beep tones
4.
Turn the confirmation and band edge beep tones out-
put level limiting ON or OFF.
When you set this item to ON, the beep tones are ad-
justed by the [AF] control until rotating the [AF] control
reaches to the specified level. Further rotation will not
increase the volume of the beep tones.
control.
85
[ ]
[MENU]
Displays the Set mode
-
item name and number
SET L C D C o n t r a s t
Ù Ú
1
Select the item
5.
Turn the confirmation beep ON or OFF.
Set the beep output level in the "Beep Level" item, as
described to the left.
tion)
switch is pushed.
-
6.
When you tune into or out of an amateur band's fre-
quency range, you can hear a beep tone.
program a total of 30 band edge frequencies in the
"User band Edge" item.
You can set the beep output level in the "Beep Level"
item as described to the left.
[ ] [ ]
[F-3] [DIAL]
Displays the option
5 0 %
Reset to the default
setting
default amateur band's frequency
range, a beep sounds.
programmed amateur band's fre-
quency range, a beep sounds.
programmed amateur band's fre-
quency range, a beep sounds.
In addition, transmission is inhibited
outside the programmed range.
-