User Set Mode - Icom IC-F5062 Instruction Manual

■ User set mode

User set mode is accessed with [User Set Mode] and allows
you to set seldom-changed settings. In this case you can
"customize" the transceiver operation to suit your prefer-
ences and operating style.
Entering the user set mode:
q While pushing and holding [P1] and [P2], push [
the power ON.
• Turn power OFF in advance.
• You should hold [P1] and [P2] until "SET MODE" appears on
the display.
[P1] [P2]
w Push and hold [P0] for 1 sec. to enter user set mode.
[P0]
] to turn
[ ]
e Push [P0] several times to select the appropriate item.
Then, push [Up] or [Down] to set the desired level/condi-
tion.
• Available set mode functions are Backlight, LCD Contrast,
Beep, Beep Level, Ringer Level, Squelch Level, AF Mini-
mum Level, Microphone Gain, Horn, Signal Monitor and
Lone Worker.
[P0]
r Push and hold [
] for 1 sec. to turn power OFF, then ON
again to exit set mode.
User set mode is also available using a programmable key.
Please refer to p. 7 [User Set Mode] section for instructions
regarding using the key assigned for user set mode.
NOTE: [Up], [Down] and [P0] activate while in the user
set mode regardless of the assigned key functions.
2
BASIC OPERATION
[Up]/[Down]
[ ]
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
12