Resetting The Cpu; D Partial Reset - Icom IC-7410 Instruction Manual

D
If you want to reset the operating parameters to their
default values (VFO frequency, VFO settings, menu
group's contents) without clearing certain data as de-
scribed below, a partial reset can be performed.
The following data will not be cleared when doing a
Partial reset:
q First, turn OFF the transceiver power.
w While holding down [F-INP ENT] and [VFO/MEMO],
push [POWER] to turn ON the power.
RESET," then the initial VFO frequencies when reset-
ting is complete.
disappears, the resetting will be cancelled.
e If desired, edit the Set mode settings after resetting.
D
The display may occasionally display erroneous infor-
mation (e.g. when first applying power). This may be
caused externally by static electricity or by other fac-
tors.
If this problem occurs, turn OFF the power. After wait-
ing a few seconds, turn ON the power again. If the
problem persists, perform the following procedure.
Resetting the CPU CLEARS all programmed
contents and returns them to their default settings.
q First, turn OFF the transceiver power.
w While holding down [F-INP ENT] and [M-CLR],
push [POWER] to turn ON the power.
then when resetting is complete, then displays the initial
VFO frequencies.
appears, the resetting will be cancelled.
e If desired, edit the Set mode settings after reset-
ting.
[POWER]
[POWER]
-
13
MAINTENANCE
[VFO/MEMO] [F-INP ENT]
[F-INP ENT] [M-CLR]
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
100