Set Mode Description - Icom IC-7410 Instruction Manual

10
SET MODE
Set mode description (Continued)
17.
Whenever you push [PTT], the internal or external an-
tenna tuner automatically starts tuning if the operating
tuned frequency.
you push [PTT] on a new frequency, if the in-
ternal antenna tuner is ON.
(External antenna tuner) Tuning always starts
when you push [PTT] on a new frequency, re-
gardless of whether the external antenna tuner
is ON or OFF.
18.
Select the desired antenna.
The selected antenna's preset memory* is cleared by
holding down [CLR](F-4) for 1 second.
* The variable capacitor settings are memorized as a
preset point for each frequency range (100 kHz steps)
after the tuner matches an antenna.
is cleared.
is cleared.
19.
Set the antenna switch function to Auto, Manual or OFF.
When you change the operating frequency, this func-
tion will automatically select the correct antenna, or you
must do it manually.
[ANT1] connector is always selected.
ory is automatically selected. You can also
manually change the antenna by pushing
87
20.
21.
Select English or Japanese as the speech language.
22.
Select HIGH (faster) or LOW (slower) speech speed.
23.
The signal level announcement with the voice synthe-
sizer can be turned ON or OFF.
frequency is announced.
are announced.
24. SPEECH [MODE] SW
Turn the Operating Mode Speech function ON or
OFF.
When this function is ON, the selected operating mode
is verbally announced when a mode switch is pushed.
25.
Set the number of available memo pads to 5 or 10.
See page 74 for details.
26.
Set the Auto Tuning Step function for [DIAL]. When
rapidly rotating [DIAL], the tuning step automatically
changes as selected.
-
There are two types of auto tuning steps: LOW (Faster)
and HIGH (Fastest).
step is set to 1 kHz or smaller steps; approxi-
mately 2 times faster when the tuning step is
set to 5 kHz or larger steps.