Icom IC-7410 Instruction Manual page 85

A programmed scan searches for signals between
Program Scan Edge channels "P1" and "P2."
Before starting the programmed scan, scan edges
must be programmed into these channels.
Refer to " Memory Channel programming" to pro-
gram Program Scan Edge channels. (p. 70)
If the same frequencies are programmed into the
Program Scan Edge channels, the programmed
scan will not start.
q Push [VFO/MEMO] to select the VFO mode.
w Push a mode switch to select the desired operating
mode (p. ).
ning.
e Push [TS] one or more times to select a tuning step.
(p. 27)
r Push [MENU] once or twice to display the "M2"
screen (Menu 2).
t Push [SCAN](F-1) to display the "SCAN" screen.
y Rotate the [RF/SQL] control to set the squelch to
open or closed.
setting when the scan was started. See page 76 for de-
tails.
squelch is always open in the SSB, CW and RTTY
modes. (pp. 2, 32, 86)
u Push [PRO](F-1) to start or cancel the programmed
scan.
blink while scanning.
D
When a signal is received during Fine programmed
scan, the scanning tuning step is temporarily set to
10 Hz and the scan speed decreases.
q Start the programmed scan.
q through u as described above.
w While scanning, push [FIN](F-3) to switch the scan
function between a programmed scan and a Fine
programmed scan.
ning.
e Push [PRO](F-1) to cancel the scan.
[SCAN]/[PRO]
-
[RF/SQL] [MENU]
SCAN
P R O
F
PROG
SCAN
∂ F
P R O
While Programmed scanning
PROG
SCAN
∂ F
P R O
F−PROG
SCAN
-
∂ F
P R O
While Fine programmed scanning
SCANS
[VFO/MEMO] [TS]
Mode switches
: 1 0 k
F
F I N SPAN S E T
SCAN
F I N SPAN S E T
SCAN
F I N SPAN S E T
SCAN
F I N SPAN S E T
8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
78