Set Mode; E What Is Set Mode; Beset Mode Construction; Wh Beep Tone - Icom IC-707 Instruction Manual

Wi What is SET mode?
SET mode allows you to customize your IC-707.
According to your requirements, select the following
settings.
W SET mode construction
To select SET mode, while
pushing the [LOCK] and [TS]
switches, turn the power ON.
Selectable operating modes
LSB
J
hi
Lyi
Beep tone
-j
C =>
@ =
<
oS @
CI-V address
Lig Mm x =
ty
[
CI-V baud rate
ny cI cI
ALL
6
SET MODE
NOTE: Each display in the box below shows the
initial setting before shipping or after CPU re-
setting.
After SET mode settings, to exit SET
mode, turn the power OFF.
Select ON or OFF for each
mode.
— ON: The mode is selectable.
— OFF: The mode is not select-
able.
— ON: The speaker emits beep tones for
switch operation.
— OFF: The speaker does not emit beep
tones for switch operation.
— ON: The scan pauses for 10 sec. when a
signal is received.
— OFF: The scan is cancelled when a signal
is received.
— AH-3: For an optional AH-3 HF AUTOMATIC
ANTENNA TUNER.
— AT-160: For an optional AT-160 HF AUTO-
MATIC ANTENNA TUNER.
-—3EH: Icom standard address for the
IC-707.
— 01H — 7FH: If required, these addresses
are selectable.
— 1200 bps: Icom standard baud rate.
— 300, 4800, 9600 bps: If required, these
baud rates are selectable.
— ON: Transceive function is activated.
— OFF: The transceive function is cancelled.
— ON: For transceive operation with the
IC-735.
— OFF: For transceive operation with other
transceivers.