Frequency Setting; Tuning Step Function; Basic Transmit Operation - Icom IC-7410 Instruction Manual

3
BASIC OPERATION
Frequency setting (continued)
D
The operating frequency can be changed in "kHz"
steps for quick tuning. You can set a tuning step in
each operating mode.
q Push [TS] to turn ON the Quick Tuning function.
Z" appears above the 1 kHz digit.
w Hold down [TS] for 1 second to display the "TS"
screen (Tuning Step).
e Select a desired operating mode.
r Rotate [DIAL] to select a tuning step.
ting, if desired.
t Repeat steps e and r to select quick tuning steps
for other modes.
y Push [TS] to exit the "TS" screen.
again.
quency will be changed in 10 Hz steps.
tion must be turned ON first.
D
You can change the frequency in 1 Hz steps for fine
tuning.
q If the Quick Tuning function is ON, push [TS] to
turn OFF.
w Hold down [TS] for 1 second to turn the 1 Hz tuning
step ON or OFF.
1 Hz tuning steps.
[UP]/[DN] switches of the microphone are used
for frequency tuning (if the Quick Tuning function
is OFF.)
D
⁄
1
4
The dial speed is reduced to
1
when the ⁄ Tuning Step function is ON, for finer tun-
4
ing control.
q Push [MENU] to display the "M1" screen (Menu 1).
w Push [1⁄4](F-3) to turn the
ON or OFF.
" appears when the
27
∂TX are used, they also tune in
1
⁄ of the normal speed
4
1
⁄

Tuning Step function

4
1
⁄ Tuning Step function is ON.
4
Mode selection
-
TS
-
-
[MENU]
[F-3] [TS]
[DIAL]
Appears
S S B
1 k H z
[TS]
[DIAL]
Appears
[1⁄4]
Appears