Ip Acls - Planet SGSD-1022 User Manual

5.14.1 IP ACLs

The commands in this section configure ACLs based on IP addresses, TCP/UDP port number, protocol type, and TCP control
code. To configure IP ACLs, first create an access list containing the required permit or deny rules, and then bind the access list
to one or more ports.
Command
access-list ip
permit, deny
permit, deny
show ip access-list
ip access-group
show ip access-group
map access-list ip
show map access-list ip
access-list ip
This command adds an IP access list and enters configuration mode for standard or extended IP ACLs. Use the no form to
remove the specified ACL.
Syntax
[no] access-list ip {standard | extended} acl_name
standard – Specifies an ACL that filters packets based on the source IP address.
extended – Specifies an ACL that filters packets based on the source or destination IP address, and other more
specific criteria.
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
Table 5-46 Access Control Lists
Function
Creates an IP ACL and enters configuration mode for standard
or extended IP ACLs
Filters packets matching a specified source IP address
Filters packets meeting the specified criteria, including source
and destination IP address, TCP/UDP port number, protocol
type, and TCP control code
Displays the rules for configured IP ACLs
Adds a port to an IP ACL
Shows port assignments for IP ACLs
Sets the CoS value and corresponding output queue for packets
matching an ACL rule
Shows CoS value mapped to an access list for an interface
Table 5-47 IP ACL Commands
497
User's Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Mode
GC
STD-ACL
EXT-ACL
PE
IC
PE
IC
PE