Lldp Tx-Delay - Planet SGSD-1022 User Manual

seconds - Specifies the delay before attempting to re-initialize LLDP. (Range: 1 - 10 seconds)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
When LLDP is re-initialized on a port, all information in the remote systems LLDP MIB associated with this port is deleted.
Example
Console(config)#lldp reinit-delay 10
Console(config)#

lldp tx-delay

This command configures a delay between the successive transmission of advertisements initiated by a change in local LLDP
MIB variables. Use the no form to restore the
Syntax
lldp tx-delay seconds
no lldp tx-delay
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
The transmit delay is used to prevent a series of successive LLDP transmissions during a short period of rapid changes in
local LLDP MIB objects, and to increase the probability that multiple, rather than single changes, are reported in each
transmission.
This attribute must comply with the following rule:
(4 * tx-delay) refresh-interval
Example
Console(config)#lldp tx-delay 10
Console(config)#
Default Setting
.
601
User's Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P