Editing Vlan Groups - Planet SGSD-1022 User Manual

5.21.2 Editing VLAN Groups

Command
vlan database
vlan
vlan database
This command enters VLAN database mode. All commands in this mode will take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
Use the VLAN database
can display the VLAN settings by entering the show vlan command.
Use the interface vlan
results of these commands are written to the running-configuration file, and you can display this file by entering the show
running-config command.
Example
Console(config)#vlan database
Console(config-vlan)#
Related Commands
show vlan
vlan
This command configures a VLAN. Use the no form to restore the
Syntax
vlan vlan-id [name vlan-name] media ethernet [state {active | suspend}]
no vlan vlan-id [name | state]
vlan-id -ID of configured VLAN. (Range: 1-4094, no leading zeroes)
Function
Enters VLAN database mode to add, change, and delete
VLANs
Configures a VLAN, including VID, name and state
Table 5-68 Editing VLAN Groups
Command Mode
to add, change, and delete VLANs. After finishing configuration changes, you
Command Mode
to define the port membership mode and add or remove ports from a VLAN. The
User's Manual of SGSD-1022 / SGSD-1022P
Default Setting
s or delete a VLAN.
567
SGSW-2840 / SGSW-2840P
Mode
GC
VC