Snmp Commands - Planet SGSD-1022 User Manual

Example
Console#show cluster candidates
Cluster Candidates:
Role Mac
ACTIVE MEMBER
CANDIDATE
Console#

5.11 SNMP Commands

Controls access to this switch from management stations using the Simple Network Management Protocol (SNMP), as well as
the error types sent to trap managers.
SNMP Version 3 also provides security features that cover message integrity, authentication, and encryption; as well as
controlling user access to specific areas of the MIB tree. To use SNMPv3, first set an SNMP engine ID (or accept the default),
specify read and write access views for the MIB tree, configure SNMP user groups with the required security model (i.e., SNMP
v1, v2c or v3) and security level (i.e., authentication and privacy), and then assign SNMP users to these groups, along with their
specific authentication and privacy passwords.
Command
snmp-server
show snmp
snmp-server community
snmp-server contact
snmp-server location
snmp-server host
snmp-server enable traps
snmp-server engine-id
show snmp engine-id
snmp-server view
show snmp view
snmp-server group
show snmp group
snmp-server user
show snmp user
Description
00-30-4f-23-49-c0 24/48 L2/L4 IPV4/IPV6 GE Switch
00-40-4f-0b-47-a0 24/48 L2/L4 IPV4/IPV6 GE Switch
Function
Enables the SNMPv3 server
Displays the status of SNMP communications
Sets up the community access string to permit access to SNMP
commands
Sets the system contact string
Sets the system location string
Specifies the recipient of an SNMP notification operation
Enables the device to send SNMP traps (i.e.,
SNMPnotifications)
Sets the SNMPv3 engine ID
Shows the SNMPv3 engine ID
Adds an SNMPv3 view
Shows the SNMPv3 views
Adds an SNMPv3 group, mapping users to views
Shows the SNMPv3 groups
Adds a user to an SNMPv3 group
Shows the SNMPv3 users
Table 5-21 SNMP Command
User's Manual of SGSD-1022 / SGSD-1022P
408
SGSW-2840 / SGSW-2840P
Mode
GC
NE, PE
GC
GC
GC
GC
GC
GC
PE
GC
PE
GC
PE
GC
PE