Lldp Trunk Configuration - Planet SGSD-1022 User Manual

Layer 2 managed switches
Hide thumbs Also See for SGSD-1022:
Table of Contents

Advertisement

4.2.12.3 LLDP Trunk Configuration

Use the LLDP Trunk Configuration to specify the message attributes for individual interfaces, including whether messages are
transmitted, received, or both transmitted and received, whether SNMP notifications are sent, and the type of information
advertised.
The page includes the following fields:
Object
Admin Status
SNMP Notification
Figure 4-2-29 LLDP Trunk Configuration page screenshot
Description
Enables LLDP messages transmit and receive modes for LLDP Protocol Data
Units.
Options:
Tx only
Rx only
TxRx
Disabled
Default: TxRx
Enables the transmission of SNMP trap notifications about LLDP and LLDP-MED
changes.
Default: Enabled
This option sends out SNMP trap notifications to designated target stations at the
interval specified by the Notification Interval in the preceding section. Trap
notifications include information about state changes in the LLDP MIB (IEEE
802.1AB), the LLDP-MED MIB (ANSI/TIA-1057), or vendor-specific
LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
For information on defining SNMP trap destinations, see "Specifying Trap
Managers and Trap Types" on page 3-42. Information about additional changes
in LLDP neighbors that occur between SNMP notifications is not transmitted.
Only state changes that exist at the time of a trap notification are included in the
transmission. An SNMP agent should therefore periodically check the value of
User's Manual of SGSD-1022 / SGSD-1022P
86
SGSW-2840 / SGSW-2840P

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sgsw-2840Sgsd-1022pSgsw-2840pSgsw-2840rSgsw-2840p4

Table of Contents