Ip Igmp Snooping Query-Count - Planet SGSD-1022 User Manual

ip igmp snooping query-count

This command configures the query count. Use the no form to restore the default.
Syntax
ip igmp snooping query-count count no ip igmp snooping query-count
count - The maximum number of queries issued for which there has been no response before the switch takes action to
drop a client from the multicast group. (Range: 2-10)
Default Setting
2 times
Command Mode
Global Configuration
Command Usage
The query count defines how long the querier waits for a response from a multicast client before taking action. If a querier
has sent a number of queries defined by this command, but a client has not responded, a countdown timer is started using
the time defined by ip igmp snooping query-maxresponse-time. If the countdown finishes, and the client still has not
responded, then that client is considered to have left the multicast group.
Example
The following shows how to configure the query count to 10:
Console(config)#ip igmp snooping query-count 10
Console(config)#
Related Commands
ip igmp snooping query-max-response-time
ip igmp snooping query-interval
This command configures the query interval. Use the no form to restore the default.
Syntax
ip igmp snooping query-interval seconds
no ip igmp snooping query-interval
seconds -The frequency at which the switch sends IGMP host-query
messages. (Range: 60-125)
Default Setting
125 seconds
Command Mode
Global Configuration
Example
The following shows how to configure the query interval to 100 seconds:
User's Manual of SGSD-1022 / SGSD-1022P
647
SGSW-2840 / SGSW-2840P