Line Commands - Planet SGSD-1022 User Manual

Command Mode
Global Configuration
Command Usage
A colon (:) is required after the specified unit number and file type.
If the file contains an error, it cannot be set as the default file.
Example
Console(config)#boot system config: startup
Console(config)#
Related Commands
dir
whichboot

5.6 Line Commands

You can access the onboard configuration program by attaching a VT100 compatible device to the server's serial port. These
commands are used to set communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Command
line
login
password
timeout login response
exec-timeout
password-thresh
silent-time*
databits*
parity*
Function
Identifies a specific line for configuration and starts the
lineconfiguration mode
Enables password checking at login
Specifies a password on a line
Sets the interval that the system waits for a user to log into the
CLI
Sets the interval that the command interpreter waits until
userinput is detected
Sets the password intrusion threshold, which limits the number
of failed logon attempts
Sets the amount of time the management console is
inaccessible after the number of unsuccessful logon
attemptsexceeds the threshold set by the password-thresh
command
Sets the number of data bits per character that are interpreted
and generated by hardware
Defines the generation of a parity bit
379
User's Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Mode
GC
LC
LC
LC
LC
LC
LC
LC
LC