Interface Vlan - Planet SGSD-1022 User Manual

switchport ingress-filtering
switchport native vlan
switchport allowed vlan
switchport gvrp
switchport forbidden vlan
switchport priority default

interface vlan

This command enters interface configuration mode for VLANs, which is used to configure VLAN parameters for a physical
interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4094, no leading zeroes)
Default Setting
None
Command Mode
Global Configuration
Example
Example
The following
the VLAN:
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
Related Commands
shutdown
switchport mode
This command configures the VLAN membership mode for a port. Use the no form to restore the default.
Syntax
switchport mode {trunk | hybrid | private-vlan}
no switchport modehybrid -Specifies a hybrid VLAN interface. The port may transmit tagged or untagged frames.
access - Specifies an access VLAN interface. The port transmits and receives untagged frames only.
Enables ingress filtering on an interface
Configures the PVID (native VLAN) of an interface
Configures the VLANs associated with an interface
Enables GVRP for an interface
Configures forbidden VLANs for an interface
Sets a port priority for incoming untagged frames
Table 5-69 Configuring VLAN Interfaces
shows how to set the interface configuration mode to VLAN 1, and then assign an IP address to
User's Manual of SGSD-1022 / SGSD-1022P
569
SGSW-2840 / SGSW-2840P
IC
IC
IC
IC
IC
IC