Ip Http Secure-Server - Planet SGSD-1022 User Manual

Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#ip http server
Console(config)#
Related Commands
Ip http port

ip http secure-server

This command enables the secure hypertext transfer protocol (HTTPS) over the Secure Socket Layer (SSL), providing secure
access (i.e., an encrypted connection) to the switch's web interface. Use the no form to disable this function.
Syntax
[no] ip http secure-server
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
Both HTTP and HTTPS service can be enabled independently on the switch. However, you cannot configure the HTTP
and HTTPS servers to use the same UDP port.
If you enable HTTPS, you must indicate this in the URL that you specify in your browser: https://device[:port_number]
• When you start HTTPS, the connection is established in this way: -The client authenticates the server using the
server's digital certificate. -The client and server negotiate a set of security protocols to use for the
connection. -The client and server generate session keys for encrypting and decrypting data.
The client and server establish a secure encrypted connection. A padlock icon should appear in the status bar for Internet
Explorer 5.x or above, Netscape 6.2 or above, and Mozilla Firefox 2.0.0.0 or above.
The following web browsers and operating systems currently support HTTPS:
To specify a secure-site certificate, see "Replacing the Default Secure-site Certificate" on page 3-74. Also refer to the copy
command on page 4-34.
User's Manual of SGSD-1022 / SGSD-1022P
446
SGSW-2840 / SGSW-2840P