Switchport Voice Vlan Security - Planet SGSD-1022 User Manual

switchport voice vlan security

This command enables security filtering for VoIP traffic on a port. Use the no form to disable filtering on a port.
Syntax
[no] switchport voice vlan security
4-251
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
Security filtering discards any non-VoIP packets received on a port that are tagged with the voice VLAN ID. VoIP traffic
is identified by source MAC addresses configured in the Telephony OUI list, or through LLDP that discovers VoIP
devices attached to the switch. Packets received from non-VoIP sources are dropped.
When enabled, be sure the MAC address ranges for VoIP devices are configured in the Telephony OUI list (voice vlan
mac-address).
Example
The following example enables security filtering on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan security
Console(config-if)#
switchport voice vlan priority
This command specifies a CoS priority for VoIP traffic on a port. Use the no form to restore the default priority on a port.
Syntax
switchport voice vlan priority priority-value
no switchport voice vlan priority
priority-value -The CoS priority value. (Range: 0-6)
Default Setting
6
Command Mode
Interface Configuration
Command Usage
Specifies a CoS priority to apply to a port's VoIP traffic on the Voice VLAN. The priority of any received VoIP packet is
overwritten with the new priority when the Voice VLAN feature is active for a port.
Example
User's Manual of SGSD-1022 / SGSD-1022P
594
SGSW-2840 / SGSW-2840P