Static Multicast Routing Commands - Planet SGSD-1022 User Manual

Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The switch must use IGMPv2 or v3 snooping for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Related Commands
ip igmp snooping version

5.25.3 Static Multicast Routing Commands

This section describes commands used to configure static multicast routing on the switch.
Command
ip igmp snooping vlan mrouter
show ip igmp snooping mrouter
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id -VLAN ID (Range: 1-4094)
interface
ethernet unit/port
-unit - Stack unit. (Range: 1)
-port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-12)
Default Setting
No static multicast router ports are configured.
Command Mode
Function
Adds a multicast router port
Shows multicast router ports
Table 5-87 Static Multicast Routing Commands
649
User's Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Mode
GC
PE