Low Voltage Power Supply; Rep 3.1 Low Voltage Power Supply Assembly - Xerox DocuPrint C55 Service Manual

REP 3.1 LOW VOLTAGE POWER
SUPPLY ASSEMBLY
PARTS LIST ON PL 3.1
REMOVAL
WARNING
Switch the Main Power off and disconnect the
Power Cord.
1. Remove the following:
a. Top Rear Cover (REP 1.1).
b. Rear Cover (REP 1.2).
c. Right Side Cover (REP 1.3).
d. Paper Cassette
e. Photoreceptor Module.
f. Color Developer Module.
g. Black Developer Module.
REPAIRS/ADJUSTMENTS
REP 3.1
2. (Figure 1): Remove screws and remove the
Black Developer Connector Cover.
3. Disconnect CN201, CN702, CN703, CN704,
CN707 and FT701 from the Low voltage
Power Supply.
Figure 1. Removing the Connector Cover
2/99
4-6
4. (Figure 2): Disconnect CN1004 (AC connec-
tor next to PCU PWB). Remove the wiring
from the harness.
5. Disconnect CN202 from the Cassette PWB.
6. Remove screws and remove the Low Voltage
Power Supply.
7. If you are installing a new Low Voltage Power
Connector Supply Assembly, remove the Cassette PWB
Cover and install it on the new Power Supply.
CN1004
D4
CN202
Figure 2. Removing the Low Voltage
Power Supply
DocuPrint C55/C55mp/[NC60]
Low Voltage
Power Supply
D5