Transfer Assembly (Transfer Clamshell); Transfer Drum - Xerox DocuPrint C55 Service Manual

8. (Figure 6): Remove the inner and outer
E-Rings from the left side of the left transfer
drum Pivot Pin.
9. Push the pin in slightly until you can remove
the left side of the Exit assembly. Do not
remove the pin at this time.
10. Locate the ground wire between the Exit
Assembly and the Oil Sensor bracket.
Remove the screw securing the ground wire
to the Oil Sensor bracket.
E-Rings
Exit
Assembly
Pivot
Pin
Figure 6. Removing the Left E-Rings
REPAIRS/ADJUSTMENTS
REP 9.9
11. (Figure 7): Remove the outer E-Ring from
the right side of the right transfer drum Pivot
Pin.
12. Move the Exit Assembly to the right and
remove the Inner E-Ring.
13. Push the pin in slightly until you can remove
the right side of the Exit Assembly. Do not
remove the pin at this time.
Assembly aside.
T04A
Figure 7. Removing the Right E-Rings
2/99
4-46
14. (Figure 8):
Assembly and remove the two pins. Remove
the Transfer Assembly.
Set the Exit
E-Rings
Pivot
Pin
T04B
Figure 8. Removing the Pins and
Transfer Assembly
REPLACEMENT
NOTE: The longer pin goes on the left side. The
large E-Rings are used on the inside.
DocuPrint C55/C55mp/[NC60]
Support the Transfer Drum
Pins
T05