Transfer Drum - Xerox DocuPrint C55 Service Manual

REP 9.8 TRANSFER DRUM
PARTS LIST ON PL 11.1
REMOVAL
WARNING
Switch the Main Power off and disconnect the
Power Cord.
NOTE: You must replace the Transfer Drum
Cleaning Blade when installing a new Transfer
Drum. The blade can be easily accessed when
the Transfer Drum is removed.
1. Remove the Front Cover (REP 1.4).
2. Remove the Drum Module.
3. Place several sheets of paper over the Paper
Feeder.
4. Remove the Stripper Finger
(REP 9.1).
5. (Figure 1): Remove the left side Arm and
Spring.
6. Remove the Transfer Drum Mounting Plates.
NOTE: The left plate is spring loaded.
7. Slide the Transfer Drum Bearings out and
remove the Transfer Drum.
8. Remove the Flanges and disassemble the
Transfer Drum as required.
NOTE: When reinstalling the transfer drum be
sure to reinstall the washer between the spring
and E-Ring on the left side.
DocuPrint C55/C55mp/[NC60]
RH Mounting
Plate
Right
Bearing
Transfer
Drum
Assembly
Washer
& Spring
LH Flange
Figure 1. Removing the Transfer Drum
REPLACEMENT
LH Mounting
Plate NOTE: Before replacement, locate the V-Shaped
cutouts on the transfer drum flanges and the V in
the Transfer Drum Lower Frame.
NOTE:
Transfer Drum, rotate the Transfer Drum Flange
until the V-Shaped cutouts on the Transfer Drum
Flanges are inserted in the V of the Lower
Transfer Drum Frame.
Arm and
Flanges do NOT rotate.
Spring
Drum is installed properly, the Transfer Drum
Gear can be rotated in either direction and the
Nip Adjustment Wheels will not rotate.
1. Perform the Transfer Drum Nip check (ADJ
Left
Bearing
RH Flange
A30
Figure 2. Reinstalling the Transfer Drum
2/99
4-43
(Figure 2): When Reinstalling the
The Transfer Drum
When the Transfer
11.1).

Transfer Drum

Flange
V-Shaped
Cutout
Transfer Drum
Lower Frame
REPAIRS/ADJUSTMENTS
REP 9.8
A43