REP 10.3 TRANSPARENCY SENSOR
PARTS LIST ON PL 10.4 HARNESS
REMOVAL
WARNING
Switch the Main Power off and disconnect the
Power Cord.
1. Remove the Front Cover (REP 1.4).
2. (Figure 1): Remove six screws.
3. Carefully pry the Transfer Drum Frame away
from the lower frame and remove the
Transfer Drum Lower Frame.
Transfer Drum
Frame
Transfer Drum
Lower Frame
Figure 1. Removing the Transfer Drum
Lower Frame
REPAIRS/ADJUSTMENTS
REP 10.3
4. (Figure 2):
Disconnect the connector and
remove the Transparency Sensor.
Transparency
Sensor
Figure 2. Removing the Transparency Sensor
A33
2/99
4-48
REPLACEMENT
NOTE:
(Figure 3):
Transfer Drum Lower Frame, rotate the Transfer
Drum Flange until the V-Shaped cutouts on the
Transfer Drum Flanges are inserted in the V of
the Lower Transfer Frame. The Transfer Drum
Flanges do NOT rotate. When the Lower Frame
is installed properly, the drum gear can be
rotated in either direction and the nip adjustment
wheels will not rotate.
Transfer Drum
Flange
V-Shaped
Cutout
D24
Figure 3. Reinstalling the Transfer Drum
Lower Frame
DocuPrint C55/C55mp/[NC60]
When Reinstalling the
Transfer Drum
Lower Frame
A43A