Rep 8.11 Lower Registration Roller - Xerox DocuPrint C55 Service Manual

REP 8.11 LOWER REGISTRATION
ROLLER
PARTS LIST ON PL 8.2
REMOVAL
WARNING
Switch the Main Power off and disconnect the
Power Cord.
1. Remove the following:
a. Paper Guide (REP 8.1)
b. Paper Feed Assembly (REP 8.2).
2. (Figure 1): Remove the Waste Toner Sensor
cover and the Waste Toner Sensor.
3. Unhook the spring, slide it out the bottom,
and remove the Waste Toner Box from the
Paper Feed Assembly.
Sensor
Spring
Spring
Waste Toner
Box
Figure 1. Removing the Toner Box
DocuPrint C55/C55mp/[NC60]
4. (Figure 2):
Clutches shown.
Be especially careful with the springs they
are different.
Figure 2. Removing the Clutches and
Solenoids
Sensor Cover
and Arm
5. (Figure 3): Remove the remaining hardware
and remove the Right Feeder Frame.
Right Feeder
Frame
D13
Figure 3. Removing the Feeder Frame
Remove the Solenoids and 6. (Figure 4): Remove the Tension Lever and
Keep the parts together.
D17
REPLACEMENT
NOTE:
Box make sure it slides back and forth smoothly.
D19
2/99
4-33
Remove the Lower Registration Roller.
Lever
Lower
Registration
Roller
Figure 4. Removing the Lower
Registration Roller
When reassembling the Waste Toner
REPAIRS/ADJUSTMENTS
REP 8.11
D22