Xerox DocuPrint C55 Service Manual page 245

GP 3.3B TRANSPARENCY MODE [NC60]
PURPOSE
The purpose of this procedure is to optimize
the Transfer Bias for transparencies.
procedure has been designed to address the
following problems:
• Mistacking on the Transfer Drum (E6/E4
Jams).
• Transfer Breakdown (very high frequency,
small diameter deletions.
• Fuser oil fingers/offset (2 - 5 mm wide x
5 - 50 mm long brighter areas on the
transparency that resemble human fingers
when projected.
ADJUSTMENT
1. Press Menu Up until Service is displayed.
2. Press Item Down until OHP Mode
(Transparency) is displayed.
3. Press Value Up to display the current
setting.
DocuPrint [NC60]
4. Six choices are available, they are:
Mode
This
DEFAULT This is the best setting for Xerox
NONE This setting is used if you have
configured the IOT using Hidden
diagnostics.
1 This setting is best for minimizing
E4/E6
transparency brightness.
2 This setting is best for minimizing
transfer breakdown with maximum
transparency brightness.
3 This setting is best for minimizing
E4/E6 Jams with minimum oil
finger/offsetting defects.
4 This setting is best for minimizing
transfer breakdown with minimum
oil finger/offsetting defects.
5. Select the choice which best represents
your situation and press Enter.
2/99
6-47
Criteria
Jams with maximum
GENERAL PROCEDURES
GP 3.3