Transfer Drum; Rep 9.1 Stripper Finger Assembly - Xerox DocuPrint C55 Service Manual

REP 9.1 STRIPPER FINGER
ASSEMBLY
PARTS LIST ON PL 9.3
REMOVAL
WARNING
Switch the Main Power off and disconnect the
Power Cord.
1. Open the Printer.
2. (Figure 1): Remove the Fuser Assembly.
3. Place a sheet of paper between the Stripper
Fingers and the Transfer Drum.
Figure 1. Removing the Fuser Assembly
REPAIRS/ADJUSTMENTS
REP 9.1
4. (Figure 2): Remove the screw and remove
the Spring Clip.
5. Remove the screw and remove the Stripper
Arm.
6. Remove the Stripper Finger Assembly and
the Transparency Jam Sensor Actuator.
Spring
Clip
Stripper Finger
Assembly
A41
Figure 2. Removing the Stripper Finger
Assembly
2/99
4-36
REPLACEMENT
NOTE: If the Transparency Sensor Jam Actuator
comes off of the Stripper Finger Assembly, rotate
the Stripper Arm and reinstall the actuator over
the flats on the Stripper Shaft. Do not attempt to
" snap" the actuator onto the shaft.
NOTE:
Sensor Jam Actuator, make sure it is blocking
the Jam Sensor and moves freely.
NOTE:
Stripper
Transparency Jam Sensor Actuator, remove the
Transparency Jam Sensor, reinstall the Stripper
Stripper
Finger Assembly then reinstall the Transparency
Arm
Jam Sensor. When reinstalling the Transparency
Jam Sensor, raise the actuator and make sure
the Transparency Jam Sensor Actuator is
blocking the Transparency Jam Sensor. If you
do not install the sensor correctly, a Drum Jam
will occur at power on.
NOTE:
times by hand and check the operation of the
Stripper Fingers.
Jam
Actuator
A29
When replacing the Transparency
If you have difficulty reinstalling the
Finger Assembly because of
Operate the Stripper Solenoid several
DocuPrint C55/C55mp/[NC60]
the