Rep 9.2 Transfer Drum Cleaning Solenoid - Xerox DocuPrint C55 Service Manual

REP 9.2 TRANSFER DRUM CLEAN-
ING SOLENOID
PARTS LIST ON PL 9.1
REMOVAL
WARNING
Switch the Main Power off and disconnect the
Power Cord.
1. Remove the Front Cover (REP 1.4).
2. (Figure 1): Remove the large E-Ring
securing the Transfer Drum Assembly latch
and slide the latch off the pin. This will allow
access to the screw securing the Transfer
Drum Cleaning Solenoid.
Figure 1. Removing the E-Ring
DocuPrint C55/C55mp/[NC60]
3. (Figure 2): Remove the screw and remove
the Transfer Drum Cleaning Solenoid.
Figure 2. Removing the Transfer Drum
Cleaning Solenoid
E-Ring
REPLACEMENT
NOTE:
Cleaning Solenoid, make sure the tab on the
Cutout
solenoid is located in the cutout in the frame.
NOTE: Observe the Cleaner Assembly during
the copy quality setup.
Solenoid is energized, the Cleaning Assembly
should be cammed forward. When the Solenoid
is deenergized, the Cleaning Assembly should be
cammed away.
Tab
A31
2/99
4-37
When reinstalling the Transfer Drum
When the Cleaning
REPAIRS/ADJUSTMENTS
REP 9.2