Xerox DocuPrint C55 Service Manual page 254

3. Remove interior packaging:
a. Remove the tape by pulling straight up.
b. Follow the next three steps completely to
remove the developer packing.
c. Rotate the lever on the cardboard roller
as shown until it releases.
remove any of the tape holding the roller
to the foam
GENERAL PROCEDURES
GP 15.1 INSTALL
d. Remove the roller and the foam cylinder,
being sure to remove all FIVE seals
attached to back of the foam cylinder.
05
e. Remove the two plastic strips by pulling
them as shown. Remove the foam sheet
from the bottom of the printer as shown.
DO NOT
06
07
08
2/99
6-56
f. Remove the two clips from the transfer
drum by pulling on the strings taped to
the front of your printer.
DocuPrint C55/C55mp/[NC60]
09