Xerox DocuPrint C55 Service Manual page 145

ADJ 3.1.1B Black Density
(C55/C55mp)
CHECKING THE BLACK DENSITY
1. Press On Line to put the printer in the Off
Line mode.
2. Press Menu.
3. Press Next until <SETUP > is displayed.
Press Enter.
4. When <COLOR ADJUST> is displayed
press Enter.
5. Analyze the test page and choose the
number which represents
Density the customer desires. Keep in
mind that this is a 30% gray. Darker is not
always better.
ADJUSTING THE BLACK DENSITY
1. Perform the Black Density Check.
2. Press Next until <BLACK DENSITY> is
displayed. Press Enter.
3. When <CHOOSE NUMBER> is displayed,
press Enter.
4. Use Next/Previous to change
numerical setting.
5. Press Enter.
6. Confirm the change.
7. Analyze the test page and determine if
additional adjustment is required.
8. Press Next [6] until OK ALL CHANGES is
displayed, then press Enter [7].
9. Press On Line [0] to return the printer to
the On Line mode.
DocuPrint C55/C55mp
ADJ 3.1.1C Color Balance
(C55/C55mp)
CHECKING THE COLOR BALANCE
1. Press On Line to put the printer in the Off
Line mode.
2. Press Menu.
3. Press Next until <SETUP > is displayed.
Press Enter.
4. When <COLOR ADJUST> is displayed
press Enter.
5. Analyze the test page and choose the
the Black number which
Balance the customer desires.
ADJUSTING THE COLOR BALANCE
1. Perform the Color Balance Check.
2. Press Next until <COLOR BALANCE> is
displayed. Press Enter.
3. When <CHOOSE NUMBER> is displayed,
press Enter.
4. Use Next/Previous
numerical setting.
the
5. Press Enter.
6. Confirm the change.
7. Analyze the test page and determine if
additional adjustment is required.
8. Press Next until OK ALL CHANGES is
displayed, then press Enter.
9. Press On Line to return the printer to the
On Line mode.
represents the Color
to change the
2/99
4-57
REPAIRS/ADJUSTMENTS
ADJ 3.1.1