Gp 3.3 Transparency Mode - Xerox DocuPrint C55 Service Manual

GP 3.3 TRANSPARENCY MODE

PURPOSE
The purpose of this procedure is to optimize
the Transfer Bias for transparencies.
procedure has been designed to address the
following problems:
• Mistacking on the Transfer Drum (E6/E4
Jams).
• Transfer Breakdown (very high frequency,
small diameter deletions.
• Fuser oil fingers/offset (2 - 5 mm wide x
5 - 50 mm long brighter areas on the
transparency that resemble human fingers
when projected.
Refer to GP 3.3A for the (C55/C55mp)
Adjustment.
Refer to GP 3.3B for the [NC60] Adjustment.
REPAIRS/ADJUSTMENTS
GP 3.3
GP 3.3A TRANSPARENCY MODE
(C55/C55mp)
ADJUSTMENT
1. Press On Line to enter the Off Line mode,
This
then press Menu.
2. Press Next until MEDIA is displayed, then
press Enter.
3. Press Next until TRANSPARENCY is
displayed, then press Enter.
4. Press Next until TRANSPARENCY MODE
is displayed, then press Enter.
2/99
6-46
5. Six choices are available, they are:
Mode Criteria
DEFAULT This is the best setting for Xerox
NONE This setting is used if you have
configured the IOT using Hidden
diagnostics.
1 This setting is best for minimizing
E4/E6 Jams with
transparency brightness.
2 This setting is best for minimizing
transfer breakdown with maximum
transparency brightness.
3 This setting is best for minimizing
E4/E6 Jams with minimum oil
finger/offsetting defects.
4 This setting is best for minimizing
transfer breakdown with minimum
oil finger/offsetting defects.
6. Select the choice which best represents
your situation and press Enter.
DocuPrint C55/C55mp
maximum