Xerox DocuPrint C55 Service Manual page 132

REP 9.9 TRANSFER ASSEMBLY
(TRANSFER CLAMSHELL)
PARTS LIST ON PL 10
REMOVAL
WARNING
Switch the Main Power off and disconnect the
Power Cord.
NOTE: Be careful not to scratch the Transfer
Drum.
1. Remove the following:
a. Front Cover (REP 1.4).
b. Right and Left Side covers (REP 1.3).
c. Print Drum (GP 1).
d. Color Developer Assembly (GP 2).
e. Black Developer Assembly (GP 3).
f. Fuser (GP 5).
2. (Figure 1): Remove the two screws and the
E-Ring and remove the Harness Cover.
Harness
Cover
Figure 1. Removing the Harness Cover
REPAIRS/ADJUSTMENTS
REP 9.9
3. Locate and disconnect the following:
a. Fuser Motor Harness. This is a five wire
harness which connects to the PCU
PWB (CN110). You will have to pry open
the Noise
harness and free the harness from the
standoffs.
b. Main Connector PWB Harness. This is a
28 wire harness which connects to the
PCU PWB (CN103).
free the harness from the standoffs.
c. Fuser Connector.
harness (White & Black, heavy gauge)
which supplies AC to the Fuser. You will
have to free the harness from the
standoffs.
d. Ground Wire. This wire provides a frame
ground to
Remove the Screw securing the wire to
the Main Motor frame.
T01
4. (Figure 2):
Suppressor around this
You will have to
This is a two wire
the Transfer Assembly.
2/99
4-44
Disconnect the three wire Oil
Sensor connector (CN309) from
Connector PWB. Free the harness from
wiring clips and cut any cable ties.
CN309
Figure 2. Disconnecting the Oil Sensor
DocuPrint C55/C55mp/[NC60]
the
T02