Replacing The Ethernet Patch Cable - Mobotix M15 Manual

66
/144
M15 Camera Manual: Installation
6. Connect the sensor module cable to the sensor
module : Guide the cable through the opening in the
front element and firmly push the sensor module
cable into the connector. Apply bayonet catch as
shown and turn it clockwise until it gently snaps shut.
7. Insert the sensor module: Make sure that the
MOBOTIX lettering on the sensor module is at the
"9 o'clock" position as shown in the figure. Using
the black module wrench, turn the sensor module
clockwise until it stops.
8. Insert the security clips: To protect the modules
against unwanted rotation insert the two red secu-
rity clips at the insides of the sensor modules (as
shown in the figure). Make sure that the security
clips click into place as shown in the image detail.
9. Close camera housing: Close the camera housing
as described in Section 2.2.8 .

2.2.5 Replacing the Ethernet Patch Cable

If you want to replace the pre-installed MOBOTIX patch cable (0.5 m/20 in) by a longer
one, make sure that you only use genuine MOBOTIX cables (see Section 1.4.5, «Ethernet
Patch Cable for Bayonet Catch» ).
Procedure
1. Open camera housing: Open the camera housing
as described in Section 2.2.2 .
2. Remove the patch cable : Turn the bayonet catch of
the patch cable at the inner housing cover (red circle
in figure) counter-clockwise and remove the catch.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com