Table of Contents
Advertisement
Mounting the Camera with Wall Mount
5. Mount the camera: Place the wall mount over the
drill holes and hold it against the wall. Then use the
four screws each with a washer and tighten them
using the appropriate wrench. Do not overtighten
the screws as this may damage the plastic mount.
Check that the screws are securely in place and
place the white caps on the screw heads. Then aim
the camera as described in Section 3.3 .
6. Clean sensor modules: Clean the protective glass
and the dome of the sensor modules with a clean
soft cotton cloth for optimal image results.
7. Establish a connection to the camera, check the
image: Establish a connection to the camera as described in Section 3.1, «Manual
and Automatic Operation – Overview» and the following sections. The live image
from the camera should be visible on the computer monitor. Check image sections
on the computer monitor.
The VarioFlex mount and ceiling mount must always be used for ceiling installation
(see Section «Ceiling Installation» ).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Note
75
/144
Screw caps for
lock screws
Advertisement
Table of Contents
