Table of Contents
Advertisement
74
/144
No screw anchors
are required for
wooden surfaces
Additional sealing pos-
sible, for example,
with shrink tubing
M15 Camera Manual: Installation
Procedure
1. Install and prepare the network connection: The
pre-installed patch cable attached to the camera
must be connected with the on-site network cable.
The connection can either be established using an
installed in-wall socket with RJ45 connector or, in
the case of a protruding network or patch cable,
using the MX-Patch-Box. In both cases, the con-
nection is well protected and is neither accessible
nor visible from the outside.
2. Drill the holes: Use the supplied drilling template
for the camera (found at the end of the manual
or, if used, the extended drilling template
included in the MX-Patch-Box package). Drill
the holes for the supplied screw anchors. Screw
anchors do not have to be fitted if the surface
is made of wood. To secure the mount, the sup-
plied stainless steel hex head screws will be
screwed directly into the surface later on. You
should start with a 2-mm drill bit, for example
(drilling depth just slightly less than screw length),
in order to facilitate screwing in wood.
3. Attach wall seal: Place the white rubber sealing
ring with the groove on the edge of the wall mount.
4. Connect the cable: Connect the on-site network
cable to the camera patch cable using an adapter
or insert the patch cable into the RJ45 outlet. Take
note of the installation manual included in the
package when using a MX-Patch-Box. All manu-
als can be downloaded and printed (as PDF files)
from the MOBOTIX website (www.mobotix.com)
in the Support > Manuals section. Make sure that
the cables are not bent or squashed.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
Interface Box
M15 Wall Mount
www.mobotix.com • sales@mobotix.com
Advertisement
Table of Contents
