Table of Contents
Advertisement
78
/144
No screw anchors
are required for
wooden surfaces
Additional sealing pos-
sible, for example,
with shrink tubing
M15 Camera Manual: Installation
Procedure
1. Convert to a ceiling mount: Simply remove the lock screw on the central joint and
exchange the wall mount for the supplied ceiling mount. Before fastening the ceil-
ing mount to the central joint (using the screw of the wall mount), the patch cable is
guided through one of the four openings.
2. Install and prepare the network connection: Guide
the pre-installed camera patch cable through one
of the four openings in the ceiling mount (this will
be connected later with the network cable using a
suitable adapter, for example, in an existing cavity
socket).
3. Drill the holes:Use the supplied drilling template for
the camera (found at the end of the manual). Drill
the holes for the supplied screw anchors. Screw
anchors do not have to be fitted if the surface is
made of wood. To secure the mount, the supplied
stainless steel hex head screws will be screwed
directly into the surface later on. You should start
with a 2-mm drill bit, for example (drilling depth just
slightly less than screw length), in order to facilitate
screwing in wood.
4. Attach ceiling seal: Place the white rubber seal
with the groove on the edge of the ceiling mount.
5. Connect the cable: Connect camera patch cable
via connector. Make sure that the cable is not
bent or squashed.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Advertisement
Table of Contents
