Opening The Camera Housing - Mobotix M15 Manual

First Installation Steps
6. Lock the sensor module : Using the black module
wrench, turn the sensor module clockwise until it
stops.
Repeat steps 3 to 6 for the second sensor module or the blind module, respectively.
Installing the blind module is a mandatory prerequisite when using the M15 as a mono
camera with only one sensor module.
Note that the sensor modules are not yet protected against theft and unwanted
rotation (e.g., due to vibration). In such a case, it is
mended to install the security clips (M.11)
• Section 2.2.2, «Opening the Camera Housing»
• Section 2.2.3, «Installing the Security Clips (Optional, Not
Required for M15D Kits)»
• Section 2.2.8, «Closing the Camera Housing»

2.2.2 Opening the Camera Housing

The following tasks require opening the camera housing and removing the front element
of the M15 in order to get to the interior of the M15:
• Inserting security clips at the sensor module or the
blind module, respectively.
• Exchanging the MOBOTIX Ethernet patch cable
against a longer MOBOTIX patch cable.
• Connecting an MxBus two-wire cable in order
to attach MxBus extension modules (e.g., the
«MX-GPS-Box» ).
• Connecting a MOBOTIX USB cable in order to attach
external data storage devices or an «MX-232-IO-
Box» .
• Exchanging the pre-installed SD card (4 GB) against
a larger one or as preventive maintenance measure
(see Section 3.5, «MicroSD Card Recording» ).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Caution
highly recom-
:
63
/144
Blind module