Mobotix M15 Manual page 83

Mounting the Camera with Pole Mount (Accessories)
Procedure
1. Prepare the cable: Guide the on-site network cable from
behind through the middle opening of the pole mount.
Ideally, the cable should be guided directly from the pole
into the cavity socket of the VarioFlex wall mount, where
it is connected with the camera patch cable (concealed
cabling) via an adapter (such as MX-Patch-Box).
2. Prepare the straps: Guide the two stainless steel straps
through the pole mount. The pole must have a diameter
between 60 mm and 180 mm.
3. Attach pole mount: Place the straps around the pole
and tighten them using a screwdriver. If necessary, the
ends of the straps can be cut off.
4. Attach rubber sealing ring: Place the white rubber seal-
ing ring with the groove on the edge of the wall mount.
5. Connect the cable: Connect the on-site network cable
to the camera patch cable using an adapter or insert
the patch cable into the RJ45 outlet. Take note of the
installation manual included in the package when using
a MX-Patch-Box. All manuals can be downloaded
and printed (as PDF files) from the MOBOTIX website
(www.mobotix.com) in the Support > Manuals sec-
tion. Make sure that the cables are not bent or squashed.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
83
/144