Mobotix M15 Manual page 7

Contents
Installation Instructions:
• This product must not be used in locations exposed to the dangers of explosion.
• Make sure to install this product as shown in Chapter 2, «Installation» of this
manual.
• When installing this product, make sure that you are only using genuine MOBOTIX
parts and MOBOTIX connection cables.
• Make sure that you are installing this product on a solid surface that provides
for a sturdy installation of the fixing elements used.
Electrical installation: Electrical systems and equipment may only be installed,
modified and maintained by a qualified electrician or under the direction and super-
vision of a qualified electrician in accordance with the applicable electrical guidelines.
Make sure to properly set up all electrical connections.
Electrical surges: MOBOTIX cameras are protected against the effects of small elec-
trical surges by numerous measures. These measures, however, cannot prevent the
camera from being damaged when stronger electrical surges occur. Special care
should be taken when installing the camera outside of buildings to ensure proper
protection against lightning, since this also protects the building and the whole
network infrastructure.
Max. power consumption of attached extension modules: The power consump-
tion of all attached MxBus modules must not exceed 3 W . When attaching modules
to the MxBus connector and the USB connector, the power consumption of all
attached modules must not exceed 4 W ,
PoE class 2 the power consumption of all attached modules must not
If is used,
exceed 1 W!
Never touch the dome or the protective lens covers: Due to the high performance
of the M15, the area of the image sensor can get quite hot, especially when the
ambient temperature is also high. This does not affect the proper functioning of the
camera in any way. For this reason, the product must not be installed within the
reach of persons without domes or protective lens covers.
Power off before opening the camera: Make sure the power supply is disconnected
before opening the camera (i.e., for installing or replacing sensor modules and SD
cards).
Network security: MOBOTIX products include all of the necessary configuration
options for operation in Ethernet networks in compliance with data protection laws.
The operator is responsible for the data protection concept across the entire system.
The basic settings required to prevent misuse can be configured in the software and
are password-protected. This prevents unauthorized parties from accessing these
settings.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Safety Warnings
if the camera is powered by PoE class 3
7
/144
.