Mobotix M15 Manual page 79

Mounting the Camera with Ceiling Mount
6. Mount the camera: Place the ceiling mount over
the drill holes, use the four screws each with a
washer and tighten them using the appropriate
screwdriver. Do not overtighten the screws as this
may damage the plastic mount. Check that the
screws are securely in place and place the white
caps on the screw heads. Then aim the camera
as described in Section 3.3 .
7. Clean sensor modules: Clean the protective glass
and the dome of the sensor modules with a clean
soft cotton cloth for optimal image results.
8. Establish a connection to the camera, check the image: Establish a connection to the
camera as described in Section 3.1, «Manual and Automatic Operation – Overview»
and the following sections. The live image from the camera should be visible on the
computer monitor. Check image sections on the computer monitor.
The VarioFlex mount and wall mount must always be used for wall installation (see
Section 2.3, «Mounting the Camera with Wall Mount» ).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Note
79
/144
Screw caps for
lock screws