Mobotix M15 Manual page 125

Virtual PTZ and Full Image Recording
Sensor Configuration (Only with Two Sensor Modules)
Sensor configuration specifies which sensor module is connected to which of the camera's
connections (Cam1 or Cam2), and in which camera image (left/right) the sensor module
is to appear for the dual image display. Open the corresponding dialog box here: Admin
Menu > Sensor Configuration.
You should also open the Sensor Configuration dialog box in the following cases:
• Swapping the displayed camera images : You wish to display the left camera image
on the right (and vice versa) without having to replug the sensor module cables on
the camera itself.
• Replacement of sensor modules : In this case, the M15D detects after startup that
the sensor modules have been replaced and indicates this through an alert super-
imposed on the live image as well as through a system message (Admin Menu >
System Messages; see Section 3.4.3, «Special M15 Configuration in the Browser» .
• Adding/switching on sensor modules: This is where you can re-enable deactivated
modules.
• Removing/switching off sensor modules : This is where you can deactivate any
connected modules if needed.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
125
/144