Table of Contents
Advertisement
118
/144
L
R
Left and right camera
images from two sensor
modules (M15D)
M15 Camera Manual: Operating The Camera
Complete the steps described below in the browser window:
1. Log the camera on and boot it as described in Section 3.2, «First Images and
the Most Important Settings» . Depending on the number of sensor modules used,
proceed as follows:
– One sensor module: Proceed with step 2.
– Two sensor modules: In this case, the remaining steps need to be executed
separately for each sensor module. Specify each sensor module's installation
position separately in the Installation (right) and Installation (left) Quick Control
fields for the right and left sensor module (i.e., camera image), respectively. If
you need to use the OnScreen Control (see next section), click into the correspond-
ing sub image when viewing a dual image or show the image of only one sen-
sor module.
2. Select installation position wall/ceiling/floor: Click Installation in the Quick Control
panel and then select Wall, Ceiling or Floor according to the installation position
of the camera. Ceiling always means that the orientation of the camera or sensor
module is from top to bottom and for Floor, the camera or sensor module's orienta-
tion is from bottom to top .
As a result, you will get a perspective-corrected panorama view for each image
sensor matching the specified installation position. Panorama view is configured as
the factory setting and it can be changed as described below.
3. Switch to the Display Mode Quick Control.
4. Set the mode that you want to be the standard view. For demonstration purposes,
the descriptions below describe the typical display mode for the wall mount and
the ceiling mount, Panorama and Surround respectively. Every other display mode
can be operated in the same way.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Advertisement
Table of Contents
