Table of Contents
Advertisement
First Installation Steps
2. Place the camera on its right side (as seen by the
camera) as shown. Push the cable of the left sensor
module under the retaining lug at the screw bore
(red circle in detail figure)
When inserting the
front element, the
sensor cables must
not come between
the guides at the
side of the housing,
since this will destroy
the cables!
3. Push the front element into the housing and make
sure that the sensor module cable remains under
the retaining lug (red circle in detail image).
4. Continue to push the front element into the hous-
ing, then evenly press the front element into the
housing at the spots indicated by the red arrows.
5. Using the supplied 5 mm Allen wrench, tighten
the two bolts at the back of the camera housing.
Push the two rubber plugs back into the opening
of the screws to prevent humidity and dirt from
entering the camera.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Caution
71
/144
Do not forget to apply
rubber plugs at the
back of the housing!
Advertisement
Table of Contents
