Power Trim And Tilt Motor Disassembly And Assembly - Suzuki GF60A Service Manual

2B-23 Power Trim and Tilt:
Installation
Installation is reverse of removal with special attention to
following steps.
• Ensure that the drive joint (1) is aligned and firmly
inserted into the gear pump assembly.
• Fit O-ring (2) to PTT motor.
2
4
• Check the level of PTT fluid contained in the pump
and reservoir. If level is low, add recommended PTT
fluid until level with mating surface of PTT motor.
• Ensure that the faces of the PTT motor and pump
reservoir are free of dirt or debris.
When attaching the PTT motor to the PTT body (3),
ensure that the tip of armature shaft (4) fits firmly into
the drive joint (1).
• Tighten the four screws (5) to specified torque.
Tightening torque
PTT motor screw (a): 6 N·m (0.6 kgf-m, 4.3 lbf-ft)
• Pour recommended PTT fluid into reservoir until
specified level.
• Perform the air bleeding procedure.
Refer to "Power Trim and Tilt Unit Reassembly" (Page
2B-19).
Power Trim and Tilt Motor Disassembly and
Assembly
Disassembly
1
3
IAJ611220064-01
5
(a)
IAJ611220068-01
1) For correct assembly, scribe an alignment mark on
the field case and brush holder.
2) Remove the three screws (1) securing the field case
to the brush holder.
1
3) Using a soft face hammer, gently tap the field case
from side to side to unseat it from the brush holder.
Slide the field case upward and away from the brush
holder.
Note the position of the O-ring encircling the brush
holder.
Slide the armature free of the brushes.
2
1
3
4
5
1. Screw
2. Field case
3. Armature
ZAJ6112206011
IAJ611220067-01
IAJ611220012-01
4. O-ring
5. Brush holder