Propeller / Nut / Cotter Pin Inspection; Lower Unit Removal And Installation - Suzuki GF60A Service Manual

Propeller / Nut / Cotter Pin Inspection

Refer to "Propeller / Propeller Nut and Cotter Pin
Inspection" in Section 0B (Page 0B-16).

Lower Unit Removal and Installation

Removal
WARNING
!
Always disconnect the battery cable, before
removing lower unit.
1) Shift to "Neutral" position. Remove bolt and trim tab
(1) (if necessary).
2) To separate the clutch rod from the shift rod, loosen
the clutch rod lock nut (2), then unscrew the
connector (3).
3
2
3) Remove six bolts (4) and separate gearcase (5) from
driveshaft housing.
4
5
Installation
ZAJ6113106003
1) Insert two dowel pins (1).
2) Apply water resistant grease to driveshaft splines.
ZAJ6113106004
3) Apply a light coating of suzuki silicone seal to mating
1
4) Slide the lower unit (2) into place, ensuring that the
IAJ611310004-01
5) Apply suzuki silicone seal to six gearcase bolts (3)
IAJ611310005-01
IAJ611310006-01
Right Hand Rotation Unit:
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
surfaces of gearcase and driveshaft housing.
: Sealant 99000–31120 (SUZUKI Silicone
Seal (50 g))
1
top of driveshaft engages properly with crankshaft
and that water tube locates in water pump case
outlet.
and tighten them to specified torque.
: Sealant 99000–31120 (SUZUKI Silicone
Seal (50 g))
Tightening torque
Gearcase bolt (a): 23 N·m (2.3 kgf-m, 16.6 lbf-ft)
3
(a)
3A-5
1
IAJ611310007-01
2
IAJ611310008-02