Engine Holder / Oil Pan / Driveshaft Housing / Mounts Disassembly - Suzuki GF60A Service Manual

Engine Holder / Oil Pan / Driveshaft Housing /
Mounts Disassembly
1) Remove the power unit. Refer to "Power Unit
Removal and Installation" in Section 1D (Page 1D-
14).
2) Remove the lower unit. Refer to "Lower Unit
Removal and Installation" in Section 3A (Page 3A-5).
3) Remove the screw and bonding wire (1).
4) Remove the bolts securing harness clamp plates to
engine holder, then remove the engine wiring
harness (2).
Disconnect the fuel cooler water hose (3) from
engine holder.
3
5) Remove the four bolts (4) securing the STBD /
PORT lower mount covers, then detach the mount
covers (5).
4
5
ZAJ6112106004
1
IAJ611210032-01
2
IAJ611210033-01
IAJ611210034-01
Housing and Bracket:
6) Unscrew and remove STBD / PORT lower mount
nuts (6) and washers (7).
7
6
7) Remove the seven bolts and the mount case cover
(8).
8
8) Remove STBD / PORT upper mount nuts (9) and
washers.
2A-13
6
IAJ611210035-01
IAJ611210036-01
IAJ611210037-01
9
IAJ611210038-01